I secured the coil pack mount to the engine mount structure using a trimmed aluminum angle and Adel clamps:
Coil pack bracket secured to angle
Coil pack angle secured in place, before trimming
Coil pack bracket with angle in place
On that position, I also used the top hole to secure many of the engine wires with another Adel clamp:
Coil pack angle secured to the engine mount
Some people have asked me for a drawing to reproduce that part - here's the closest thing to that:
Coil pack angle with approximate dimensions
Coil pack angle secured in place (top view)
Coil pack angle secured in place (bottom view)
I also installed the oil pressure hose from the engine to the sensor:
Oil pressure hose from engine to sensor
This section also has you run the heat valve control cables to the panel (I'd expect that to be part of section 50, but oh well), so we attached those - one of the center side panel, the other to the center console insert, routed them through the firewall, and attached the center console in that position:
Heat valve cable secured opposite to electrical wires over the tunnel
Running the heat valve cable over the tunnel
Heat valve cables (on the copilot side and passenger console) installed in place
The main things left for this section are securing the heat control cables to the firewall and valves, and connecting the MAP sensors.
No comments:
Post a Comment