Damazio family's RV-10 project
Mid-fuselage ribs deburring
I spent quite a bit of time deburring parts for primer. No pictures, only the video below.
Total mid-fuselage ribs rivets:
Total mid-fuselage ribs time:
Rodrigo Damazio Bovendorp
December 15, 2018
Share to Twitter
Share to Facebook
Share to Pinterest
Post a Comment
Post Comments (Atom)
Update on tailcone mods
Now that the tailcone is all drilled, I'm revisiting the mods I had planned to see what I need to do before primer. I made a previous po...
This is a long delayed post, but only now I got to write it. Since antennas are not part of the standard kit, I've been researching wh...
Bottom wing skins: pitot mount and flap gap fairing riveting
I replaced the bad rivets behind the inboard bottom wing skin with CR3212s (and one CR3242) as recommended by Van's, for much better res...
Research: empennage mods
Another two pieces of research on mods the empennage I've been looking at are fitting a camera to the top of the vertical stabilizer and...
We decided to build the wing stand following the plans posted by someone else: (can't find the original source of this to give credit...
Empennage kit is here!!
After a grumpy FedEx delivery guy who kept complaining about the size and weight of the box, it's finally here! The box Crackin...
Tailcone mods and considerations
As I start to build the tailcone (post on that later), I'm looking at what kinds of mods I need to top in addition to what's on the ...
Fuel tank assembly complete
The tank comes mostly assembled, with a few finishing items not yet done. The first task was to remove the tanks, which was easy but time-...
More tailcone riveting
1161 rivets later, I'm probably about halfway done in riveting the tailcone: Side skins mostly riveted I had a lot of help here, so...
Elevators almost ready to prime
While waiting for my wife to be back from vacation (to help me with bending the rudder leading edges), I did a lot of work on the elevators,...