Damazio family's RV-10 project
Firewall deburring and countersinking
I finished deburring and countersinking the firewall parts:
with this, most firewall parts are ready for primer:
Total firewall time:
Rodrigo Damazio Bovendorp
December 15, 2018
Share to Twitter
Share to Facebook
Share to Pinterest
Post a Comment
Post Comments (Atom)
Update on tailcone mods
Now that the tailcone is all drilled, I'm revisiting the mods I had planned to see what I need to do before primer. I made a previous po...
This is a long delayed post, but only now I got to write it. Since antennas are not part of the standard kit, I've been researching wh...
Research: empennage mods
Another two pieces of research on mods the empennage I've been looking at are fitting a camera to the top of the vertical stabilizer and...
Bottom wing skins: pitot mount and flap gap fairing riveting
I replaced the bad rivets behind the inboard bottom wing skin with CR3212s (and one CR3242) as recommended by Van's, for much better res...
Empennage kit is here!!
After a grumpy FedEx delivery guy who kept complaining about the size and weight of the box, it's finally here! The box Crackin...
We decided to build the wing stand following the plans posted by someone else: (can't find the original source of this to give credit...
Tailcone mods and considerations
As I start to build the tailcone (post on that later), I'm looking at what kinds of mods I need to top in addition to what's on the ...
Elevators almost ready to prime
While waiting for my wife to be back from vacation (to help me with bending the rudder leading edges), I did a lot of work on the elevators,...
Fuel tank assembly complete
The tank comes mostly assembled, with a few finishing items not yet done. The first task was to remove the tanks, which was easy but time-...
More tailcone riveting
1161 rivets later, I'm probably about halfway done in riveting the tailcone: Side skins mostly riveted I had a lot of help here, so...