I match-drilled the trim assembly to the cover plate:
Match-drilling trim assembly screw holes into cover plate
then dimpled the holes, installed nutplates and screwed them together:
Aileron trim assembly attached to cover plate
Cover plate with aileron trim assembly underneath
I ran the servo to find the center position, then marked it on the links:
Center position marks on the aileron trim links
The next steps require the aileron pushrods to be installed and adjusted, which can only happen after the tanks are in place, which in turn is pending on installing the fuel return brackets, which are pending an order for 3/8" NPT tap. Time lapse:
Total aileron trim time: 5.6h Total aileron trim rivets: 12
No comments:
Post a Comment