I also fabricated doublers from .040 stock for the side channels in order to open more holes through them - the parts come with only two holes, and even though Van's says it's ok to open a third, I'll rest easier with this reinforced:
 |
| Doublers cut to size |
 |
| Doublers match-drilled |
 |
| Fully-drilled doublers for having more holes passing conduits and air lines |
The goal is to run 3 conduits through each side, pitot+AoA on the left and static air on the right.
I also, again per advice from VAF, countersunk the two holes on each of the forward center section bulkhead side channels that will need to de riveted double-flush:
 |
| Flange holes (top center) were countersunk for double-flush rivets |
Next, I need to prime all these parts and start riveting.
Time lapse:
Total mid-fuselage bulkhead time: 33.3h
No comments:
Post a Comment